The gentle 8.5 degree slope allows cars with low front spoilers (bars) to edge the car onto the ramp, the wheel raises up to to its lift height and then drops slightly into its holding position.
The dimensions shown in the diagram illustrate the precision calculations of this ramp that allow the car to move up and be held in the lift position.
The ramps are made from plastic moulds with honeycomb design to promote strength which allows the ramp to support up to 3T in capacity. The honeycomb design also allows the ramp to be fixed to flooring if required.
The plastic construction minimises the chance of damage to a vehicle should the ramp contact the vehicle.
These can be freighted for free when purchased at the same time as one of our 2 post hoists.

About Happ HAPP is a Company created by car enthusiasts for car enthusiasts. Car clubs asked us to change the game and we did. We take our job seriously and will only offer you the best products that we can source. We have sold hoists all across Australia. Our prices are the best, with quality and service assured.
Thanks for the great service during our recent purchase of a HAPP30 4t two post hoist. Hoist arrived well packed for shipping and was a breeze to install and operate with the supplied instructions. The quality of the hoist surpassed my expectations c...
HAPP35 – 2 post floor plate hoist – Earl Fontaine – June 10, 2012
Hi Maree, just a quick note about the tyre machine and the wheel balancer that I purchased recently.
The tyre changer has seen plenty of use. I have 5 motorbikes (dirt bikes, dual sport and sports bike) 2 Camaro’s and the families cars to look afte...
Tyre Changer, TC10 and Wheel Balancer, WB10 – Warwick Leahy – June 29, 2016